IKA C 2000 basic - Performing the Measurement Process

3UHSDULQJ DQGSHUIRUPLQJPHDVXUHPHQWV
IKA

-WERKE C 2000 basic / control Ver. 04 08.07
3DJH
j
Close the decomposition vessel (C 5010, C 5012 or C 62).
Place the cover onto the lower section and push down until it presses against the
stop piece in the lower section.
C 5010 C 5012 C 62
Place the union nut onto the lower section and tighten by hand.
The decomposition vessel can now be filled.
 3HUIRUPLQJWKHPHDVXUHPHQW
c
Guide the decomposition vessel into the filler head of the open measuring cell cover
until it catches in place.
$OZD\VKROGWKHGHFRPSRVLWLRQY HV VHOVHFXUHO\RQWKHWRSE\WKHFDSVFUHZ
The decomposition vessel maintains a defined position in the holder on the fill head
by being lowered at the centre of the fill head by 0.8 mm. A spring element then
makes contact with the electrical ignition contact on the decomposition vessel.
7KH GHFRPSRVLWLRQYHVVHO LV QRZ VXVSHQGHG YHUWLFDOO\ LQ WKH UHFHLYLQJ DUHD
FKHFNHYHU\WKLQJRQHODVWWLPH
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com