13
MS1/2 122004
Max. speed Touch- Continuous
[rpm] operation mode operation mode
MS 1.1 2500 yes no
Standard attachment
MS 1.2 1400 yes yes
One-hand attachment
MS 1.3 1400 no yes
Test tube attachment with
one-hand insert
MS 1.4 800 no yes
Microtiter plate attachment
If the shaker is screwed down (i.e. built into a system), please
note that dynamic forces can be generated during operation as a
result of unfavourable loading and a poor centre of gravity positi-
on. This could cause the surrounding area to vibrate or induce
uncontrollable vibrations in the table. If you notice that the appli-
ance is not running smoothly, reduce the speed until it runs smoo-
thly again.
The shaker MS 1 and MS 2 are maintenance-free. It is sub-
ject only to the natural wear and tear of components and their sta-
tistical failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been cleaned
and is free from any materials which may constitute a health
hazard. Please tell us if you have used any materials which are
dangerous or which may constitute a health hazard.
Use only cleansing agents which have been approved by IKA
to clean IKA devices.
To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside/
isopropyl alcohol
Cosmetics water containing tenside/
isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information from
IKA. Wear the proper protective gloves during cleaning of the
devices. Electrical devices may not be placed in the cleansing
agent for the purpose of cleaning.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with the manufactu-
rer that this method does not destroy the instrument.
Designation Description Id-No. MS 1 MS 2
MS 1.1
For small tubes and vessels
L001260 X X
Standard attachment
upto diameter 30 mm
MS 1.2 Consisting of MS 1.3 L001900 X X
One-hand attachment and MS 1.21
MS 1.3 Attachment for inserts L001490 X X
Test tube attachment
MS 1.21, MS 1.31, MS 1.32,
MS 1.33, MS 1.34
MS 1.4 For microtiter plate L001280 X -
Microtiter plate attachment
MS 1.21 For vessels with flat L001540 X X
One-hand insert base
MS 1.31 For 14 vessels L001840 X X
Test tube insert with diameter 8 mm
MS 1.32 For 6 vessels L001850 X X
Test tube insert with diameter 10 mm
MS 1.33 For 4 vessels L001860 X X
Test tube insert with diameter 15 mm
MS 1.34 For any number of L001830 X X
Test tube insert bore holes
Maintenance and cleaning
Accessories
3453900_BA MS1_MS2_122004 11.04.2005 9:29 Uhr Seite 13
To Next Page
Loading...
