where they can be accessed by everyone.
• Only staff who have been trained accordingly, know the applian-
ce and are authorised to carry out work in this field should use this
appliance.
• Please follow the relevant safety instructions and guidelines, and
occupational health and safety regulations for use in the labora-
tory.
Note! Covering or parts that are capable of being removed
from the unit without accessory equipment have to be
reattached to the unit for safe operation in order to prevent, for
example, the ingress of fluids, foreign matter, etc..
• When working with the shaking unit, the user must select and
wear his personal protective equipment according to the mixing
hazard category of the medium. Defective or inappropriate protec-
tive equipment can expose the user to the risk of spurting liquids,
projectile parts or being pulled in at the shaking table or support.
• Never touch moving parts (risk
of crushing, impact and cutting,
see fig.1: point of danger)!
• Ensure that parts of the body,
hair or items of clothing cannot
be trapped by the moving parts.
• Always install the appliance on
a flat, stable non-slip base.
• Before use, please ensure that
the knob for setting the speed is at the left stop as the appliance
starts up at the last speed which was set.
• Pay attention to the vessels on the shaking table when setting
the speed. This will prevent any of the medium to be shaken from
spurting out of the sample vessels.
•
All accessories and vessels in place for the shaking process must
be firmly secured. Shaking vessels which are not properly secured
could get damaged or be projected out, thus causing injury. It is
essential to regularly check that the vessels to be shaken and the
attachments are firmly secured, especially before using the applian-
ce again.
• If you notice that the device is not running smoothly, the speed
Page
Declaration of CE-conformity 9
Safety instructions 9
Correct use 10
Unpacking 10
General information 11
Commissioning 11
Switching on and setting of the speed
Operation mode
Attachments
Supported weight and speed range
Maintenance and Cleaning 13
Accessories 13
Warranty 14
Technical data 14
List of spare parts MS 1 and MS 2 21
Spare parts diagram MS 1 and MS 2 22
We declare under our sole responsibility that this product corros-
ponds to the regulations 89/336/EG and 73/23/EG and conforms
with the standards or standardized documents
DIN EN IEC 61010-1
and DIN EN IEC 61326-1.
• In order to be able to use the appliance properly and safely, every
user must first read the operating instructions and observe the
safety instructions contained therein.
Take care of these operating instructions and keep them in a place
9
MS1/2 122004
Contents
Safety instructions
Declaration of CE-conformity
Fig. 1: point of danger
3453900_BA MS1_MS2_122004 11.04.2005 9:29 Uhr Seite 9
To Next Page
Loading...
