Need help?Do you have a question about the IKA RT 10 and is the answer not in the manual?
General| Brand | IKA |
|---|---|
| Model | RT 10 |
| Category | Laboratory Equipment |
| Language | English |
General hazard statement indicating importance for health and safety.
Failure to observe this information may be detrimental to health or may result in injuries.
Important for ensuring appliance functions without technical problems.
Important for proper use and correct appliance function, leads to accurate results.
Read operating instructions and follow safety guidelines before starting up.
Exercise caution when touching housing parts and heating plate due to high temperatures.
Caution: Only process media with a flash point higher than 180 °C.
Set safe temperature limit at least 25 °C lower than the media's fire point.
Do not operate in explosive atmospheres, with hazardous substances, or under water.
Max heating plate temperature restricted to 130 °C; device switches off heating above this limit.
Set safe temperature limit at least 25 °C lower than the media's fire point.
Switch on, wait for SAFE display, press Temp key and use +/- keys to set.
The set safety temperature is displayed and saved upon releasing the Temp key.
Error when device temperature is too high. Solution: Switch off, cool down, check plug.
Error due to break in safety circuit. Solution: Check connection, plug, or sensor.
Safety relay does not open during test. Solution: Switch off, check PCB (authorised personnel).
Safety temperature is too low during test. Solution: Switch off, check PCB/sensor (authorised personnel).
Error in heating and switching element monitoring. Solution: Check controller, switch off, check PCB.
Difference between safety and control sensor exceeds limit. Solution: Switch off, check connector/PCB.
Triac error detection is not working. Solution: Switch off, check PCB (authorised personnel).
Difference between safety and control sensor exceeds limit. Solution: Switch off, check connector/PCB.
If faults persist or other codes appear, contact service or send for repair.
To Next Page
