Why is there rust on cutlery from IKEA 904.756.16?
If you notice traces of rust on cutlery washed in your IKEA Dishwasher, there may be too much salt in the water used for washing. Refer to 'The water softener' section. Also, avoid placing silver and stainless steel cutlery together, as this can cause rust.
How to fix a leak from IKEA 904.756.16 Dishwasher door?
If you notice a small leak from your IKEA Dishwasher door, ensure the appliance is level by adjusting the feet. If applicable, adjust the rear foot to center the door on the tub.
What to do if IKEA 904.756.16 doesn't fill with water and shows i10 or i11?
If your IKEA Dishwasher won't fill with water and the display shows i10 or i11, make sure that: * The water tap is open. * The water supply pressure is not too low (contact your local water authority for information). * The water tap is not clogged. * The filter in the inlet hose is not clogged. * The inlet hose has no kinks or bends.
Why the IKEA 904.756.16 Dishwasher programme does not start?
If your IKEA dishwasher programme does not start, ensure that the appliance door is closed properly. If the delay start is set, either cancel the setting or wait for the countdown to finish. Also, the appliance may be recharging the resin inside the water softener, which takes approximately 5 minutes.
What to do if IKEA 904.756.16 Dishwasher shows i30?
If the anti-flood device on your IKEA Dishwasher is activated and the display shows i30, close the water tap. Also, ensure the appliance is installed correctly and the baskets are loaded as instructed in the user manual.
Why does the IKEA Dishwasher programme lasts too long?
If the programme on your IKEA Dishwasher is running longer than expected, check if the delay start option is activated and cancel it or wait for the countdown. Keep in mind that activating certain options can also increase the programme duration.
What to do if IKEA 904.756.16 Dishwasher shows iC0 or iC3?
If your IKEA Dishwasher shows a technical malfunction with display iC0 or iC3, try switching the appliance off and on.
How to prevent dull dishes from IKEA Dishwasher?
If you have dull, discoloured, or chipped tableware from your IKEA Dishwasher, ensure only dishwasher-safe items are washed in the appliance. Load and unload the basket carefully, referring to the basket loading leaflet. Place delicate items in the upper basket and consider activating the Gentle / Glass option for special care.
What to do if IKEA 904.756.16 Dishwasher shows i51 - i59 or i5A - i5F?
If your IKEA Dishwasher has a malfunction of the wash pump or the drain pump and the display shows i51 - i59 or i5A - i5F, try switching the appliance off and on.
What to do if IKEA Dishwasher shows i41 - i44?
If your IKEA Dishwasher has a malfunction of the water level detection sensor and the display shows i41 - i44, ensure that the filters are clean and try switching the appliance off and on.
General| Category | Dishwasher |
|---|---|
| Type | Built-in |
| Number of place settings | 13 |
| Programs | 6 |
| Depth | 55.0 cm |
Covers general safety, child protection, installation, electrical, water, and usage precautions.
Information on contacting service and proper disposal of the appliance.
Details the appliance's components and the Beam-on-Floor indicator feature.
Explains buttons, display symbols, and indicators for operating the appliance.
Details available wash programmes, their phases, and customizable options.
Guides on configuring basic settings, water softener, and entering setting mode.
Instructions on loading, using detergent, starting programmes, and managing cycles.
Provides tips for optimal cleaning, energy saving, and correct use of consumables.
Instructions for cleaning the appliance interior, exterior, filters, and spray arms.
Detailed steps for cleaning filters, inlet hose filter, and spray arms.
Addresses common problems, alarm codes, and their solutions for appliance malfunctions.
Solutions for poor washing results, drying issues, streaks, and stains on dishes.
Details technical data like dimensions, voltage, frequency, and water supply requirements.
Explains the guarantee period, coverage, exclusions, and how to obtain service.
To Next Page
