IKEA BARMHARTIG - Troubleshooting

has cooled down using cleaner for glass
ceramic or stainless steel.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if…
Problem Possible cause Remedy
The appliance cannot be ac-
tivated or is not operating.
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor-
rectly connected to the elec-
trical supply (refer to con-
nection diagram).
More than 10 seconds
passed since you activated
the hob.
Activate the appliance
again.
The Child Safety Device is on
.
Deactivate the Child Safety
Device (See the section
“Child Safety Device").
Several symbols were
touched at the same time.
Touch only one symbol.
The residual heat indicator is
not displaying anything.
The cooking zone was only
on for a short time and is
therefore not hot.
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
There is no signal when you
touch panel symbols.
The signals are deactivated. Activate the signals. Refer to
OffSound Control.
symbol plus a number
appears on the power set-
ting display.
Electronics fault. Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house’s electric
system. If after activating
again,
is displayed
again, call the After Sales
Service.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
ENGLISH 12