Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
6. With the microwave oven near the opening, plug the
microwave oven into the grounded 3 prong outlet.
7. Using 2 or more people, slide microwave oven all the way into
the opening, and center the microwave oven within the
opening.
NOTE: The screw holes in the winged ends of both side brackets
must be fully over the wood of the wall or cabinet, as shown.
A
'O
B C
A. Door front facing
B. Side bracket screw hole for cabinet attachment
C. Cabinet front
For installation in double-walled cabinetry only:
The clearance of 1/4" (6 mm)
must exist between the end of
the side bracket and the outer
wall.
If this clearance exists,
proceed to Step 8 below, and
complete installation.
If this clearance does not 1/4"(6 ram)
exist, follow these steps:
a.Wedge 1/4" (6 mm) shim between side bracket and outer
wall;
b. Use 5/64" (2 mm) drill to drill pilot hole through screw hole in
side bracket;
c. Install 1" screw, then remove shim.
d. Repeat steps a, b and c on other side.
NOTE: To ensure proper side trim panel fitting, do not
overtighten screws.
Proceed to Step 10.
8. Using 5/64" (2 mm) drill, drill pilot holes into the cabinet
through the screw holes in the side brackets.
9. Install two 1" T-10 screws in the pilot holes to secure the
microwave oven in place.
NOTE: To ensure proper side trim panel fitting, do not overtighten
screws.
10. Open microwave oven door.
11. Position the tabular portion of the side trim panel behind the
door facing frame, then firmly push the outside edge of the
trim behind the side bracket, as shown.
Exploded View of Panel Placement
A B C D
I
A. Door facing frame
B. Tabular portion (shaded) of side trim panel
C. Side bracket
D. Side trim panel in place
12. Attach the side trim panel to the door facing frame using two
1" T-10 screws.
A. Door facing frame
B. Trim panel
C. 1" T-IO screws (4)
13. Repeat steps 11 and 12 on other side.
To Next Page
Loading...
