INSTALLATIONREQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Pliers
Phillips
screwdriver
5 1
_e and V4 _...-_
nut drivers or _y
hex sockets 1_
Measuring tape
or ruler
10" adjustable wrench
opens to /_
that
11/8"(2.9 cm)
Flat-blade
screwdriver
Utility knife
UL Listed!CSA
Approved twist-on 0 _
wire connectors*
Small level S
%" open-end
wrench
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher.
Other useful items you may need:
Shallow _----__
pan _'-_._
Parts supplied:
Drain hoSe Drain #10Xw,
clamps (2) hose Phillips-head
screws (2)
(1 large and
1small)
V
2 - Under.
counter
mounting
brackets
Make sure all these parts are included in the literature package.
t®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Parts needed:
%'!Comer X %'! hose fitting
For part or kit' see local
retailer or call Whirlpool
Parts: 1,800-442.9991. Part
Number W10273460
Other parts you may also need:
11/2,,.2,!
(3,81.5 cm) duct tape
Screw-type
clamps (3 maximum)
Moisture Sid
barrier tape for Sol d surface
(Part Numl countertops
4396277) (Part Number 8212560)
NOTE: Some parts available for purchase in plumbing supply
stores. Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Toolsneeded:
C_
wi
Parts needed:
Copper tubing _y8 See "Electrical Requirements', section.
O.D.suggested) or I _ _.. :, : ' _ .. _ .
f exib e bra ded _or LJirect vwre: #or _'ower _upply
water sunn v ne Use UL Listed/ Cord: use UL
csA Appr0ved Listed/CSA
I Strain relief Appr0ved power
I to fit %, (2:2 Cm)Supply Cord kit
hole marked for use wkh
dishWasher
To Next Page
Loading...
Need help?
General
