IKEA koppla - Receiver Setup and Operation; Dimmer Receiver Installation; Dimmer Receiver Manual Control

24
RECEIVER
Dimmer receiver (fi g 2)
The receiver is only intended for
lighting.
Installation:
1. Insert the receiver in the outlet socket.
The Main lamp, green lamp, comes on
when the receiver is connected to the
mains supply.
2. Connect the lamp/lamps (max com-
bined output 300W) to the receiver.
Manual on/off:
1. Press [ON/OFF] to switch the lamp on
or off. The output lamp, the red, comes
on when the receiver powers the con-
nected lamp.
Manual brightness:
1. Press [UP] to increase the brightness.
Press [DOWN] to reduce the brightness.
The receiver ”will remember” the set
brightness, for example, if you switch
off the lamp at a set brightness level,
it will switch on the lamp at the same
level of brightness.
Deactivate reception:
1. If you do not want the receiver to
receive signals from the remote control,
press and hold down the [ON/OFF]
key on the receiver, for 3 seconds.