Problem Possible cause Remedy
There is no signal when you
touch panel symbols.
The signals are deactivated. Activate the signals. Refer to
OffSound Control.
symbol plus a number
appears on the timer dis-
play.
Electronic component error. Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again. If the
problem continues, ensure a
correct installation by calling
an authorised installer.
lights up on the timer
display.
The second phase of the
power supply is missing.
Check if the appliance is
connected correctly to the
electrical supply. Remove
the fuse, wait for one minute,
and insert the fuse again. If
the problem continues, en-
sure a correct installation by
calling an authorised instal-
ler.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your IKEA store call centre. You can find a
full list of IKEA appointed contacts at the
end of this manual.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Technical data
Rating Plate
IKEA of Sweden AB
SE - 343 81 Älmhult
21552
DGT
230 V
503.688.40
Made in Germany
© Inter IKEA Systems B.V.
Model MATMÄSSIG Typ 60 HAD 03 AO 6,5kW
PNC 949 594 433 00 S NO ............... 220V-240V AC 50-60 Hz
ENGLISH 17
To Next Page
Loading...
