Using the Booster function
The Booster function makes additional
power available to the induction cooking
zones. Touch to switch it on, a lights
up on a display. After maximum 10 minutes,
the induction cooking zones automatically
return to cooking level .
Power management
The power management shares the
maximum available power between two
cooking zones generating a pair (see
picture). Booster function can cause, that the
maximum available power for a pair is
exceeded. Then the second cooking zone
will be automatically reduced to a lower
power level. The display for the reduced
zone alternates between selected and
maximum available.
Using the Timer
Touch repeatedly until the pilot light of a
desired cooking zone displays. For example
for the front left zone.
Touch
or of the Timer to set the time
between 00 and 99 minutes. When the
pilot light flashes more slowly, the time
counts down. Set the heat settings.
If the heat setting is set and the time set has
elapsed, acoustic signal appears, 00
flashes, and cooking zone switches off. If
cooking zone is not in use and the time set
has elapsed acoustic signal appears and
00 flashes.
Select
for a cooking zone to switch off
the function, and the pilot light of the
cooking zone selected flashes faster. Touch
and the remaining time counts
backwards to 00. The pilot light goes out.
STOP+GO
The function sets all cooking zones that
operate to the lowest heat setting . When
the function operates, you cannot change
the heat setting. The function does not stop
the timer function.
• To activate this function touch . The
symbol comes on.
• To deactivate this function touch . The
heat setting that you set before comes
on.
Lock
When the cooking zones operate, you can
lock the control panel, but not . It
prevents an accidental change of the heat
setting.
First set the heat setting.
To start this function touch . The symbol
comes on for 4 seconds. The Timer stays
on.
To stop this function touch
. The heat
setting that you set before comes on.
ENGLISH
10