5
Release the locking
system to remove
the glass panels.
6
90°
Turn the two fasten-
ers by 90° and re-
move them from
their seats.
7
2
1
Carefully lift (step 1)
and remove (step 2)
the glass panels
one by one. Start
from the top panel.
Clean the glass panels with water and
soap. Dry the glass panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation
the surface of the glass panel frame on the
screen-printing zones is not rough when you
touch it.
Make sure that you install the top panel in
the seats correctly (refer to the illustration).
What to do if…
Warning! Refer to the Safety chapters.
Problem Possible cause Remedy
The oven does not heat up. The appliance is deactiva-
ted.
Activate the appliance.
The oven does not heat up. The clock is not set. Set the clock. Refer to "Set-
ting the time of day".
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The oven does not heat up. The automatic switch-off is
on.
Refer to "Automatic switch-
off".
ENGLISH 16
To Next Page
Loading...
Need help?
General