11
patible with the set wash cycle, the
indicatorlightwillashandtheop-
tion will not be activated;
- if the selected option is not
compatible with another previously
selected option, the indicator light
correspondingtotherstoptionse-
lectedwillashandonlythesecond
option will be activated; the indicator
light corresponding to the active op-
tion will light up.
8. Start the wash cycle by pressing the
button; the corresponding indica-
tor light will remain lit steady green.
To cancel the set wash cycle, pause
the machine by pressing the but-
ton and select a new cycle.
9. At the end of the wash cycle the
indicator light will light up. The
door can be opened once the DOOR
LOCKED indicator light switches off.
Take out the laundry and leave the ap-
pliance door ajar to let the drum dry.
Turn the washing machine off by
pressing the button.
Stand-by mode
In accordance with the latest energy
saving regulations, this washing ma-
chineisttedwithanautomaticswitch-
off (stand-by) system that intervenes
after roughly 30 minutes if no activity is
detected. Press the buttonbrieyand
wait for the machine to start up again.
Consumption in off-mode: 0.5 W
Consumption in Left-on mode: 8 W
This power value was measured accord-
ing to EN 60456.
ENGLISH
Daily use
Preparing the laundry
• Divide the laundry according to:
- the type of fabric / the symbol on
the label
- colours: separ
ate coloured gar-
ments from whites.
• Empty all garment pockets and
check the buttons.
• Do not exceed the values listed in
the “Wash cycle table”, which refer
to the weight of dry laundry.
How much does your laundry weigh?
• 1 sheet 400–500 g
• 1 pillow case 150–200 g
• 1 tablecloth 400–500 g
• 1 bathrobe 900–1,200 g
• 1 towel 150–250 g
Starting a wash cycle
Open the w
ater tap. Plug in the appli-
ance.
1
.
T
urn the washing machine on by press-
ing the
button. After switching o
n
f
or a few seconds, all the indicato
r
l
ights will switch off and the
indica-
tor light will pulse.
2. Load the laundry and close the door
.
W
ARNING!
Make sure that
no laundry lies
between the
seal and the
door.
This ma
y cause water to leak or may
damage the laundry.
3. Set the W
ASH CYCLE knob to the
desired cycle.
4. Set the w
ashing temperature.
5. Set the spin speed.
6. P
our the detergent and additives.
7. Select the desired options:
- if the selected option is not com-