EasyManuals Logo
Home>IKEA>Washer>STALLBAR WM 6D

IKEA STALLBAR WM 6D User Manual

IKEA STALLBAR WM 6D
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
ENGLISH
Troubleshooting
The w
ashing machine may occasionally fail to work. Before contacting the Technical
Assistance Service, make sure that the problem cannot be easily solved using the
following list.
Anomalies Possible causes / Solution:
The washing machine
does not start.
The appliance is not plugged into the socket, or not
sufcientlytomak
e
contact.
There is no power in the house.
The wash cycle does
not start.
The w
ashing machine door is not closed properly.
The ON/OFF button has not been pressed.
The START/PAUSE button has not been pressed.
The water tap has not been opened.
A delay has been set for the start time.
The washing machine
does not ll with wa-
ter (“H2O” ashes on
the display).
The water inlet hose is not connected to the tap.
The hose is bent.
The water tap has not been opened.
There is no water supply in the house.
The pressure is too low.
The START/PAUSE button has not been pressed.
The washing machine
continuously loads
and unloads water.
Thedr
ain
hoseisnotttedbetween65cmand100
cmfromtheoor
.
The free end of the hose is immersed in w
ater.
The wall drainage system does not have a breather
pipe.
•
The washing machine
does not drain nor
spin.
The cycle does not include drainage: with certain
cycles it must be started manually.
The drain hose is bent.
The drainage duct is clogged.
The washing machine
vibrates a lot during
the spin cycle.
The drum was not unlocked correctly during instal-
lation.
The washing machine is not level.
The washing machine is tucked between furniture
cabinets and the wall.
shops and help to prevent this inconvenience.
nuously. Special anti-siphon valves are available in
washing machine to fill with water and drain conti-
be problems relating to back-siphonage, causing the
on one of the upper floors of a building, there may
and/or an authorized service partner. If the home is
tact the IKEA appointed After Sales Service Provider
se the w
ater tap, switch the appliance off and con-
If the problem persists even after these checks, clo-

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IKEA STALLBAR WM 6D and is the answer not in the manual?

IKEA STALLBAR WM 6D Specifications

General IconGeneral
BrandIKEA
ModelSTALLBAR WM 6D
CategoryWasher
LanguageEnglish

Related product manuals