IKEA TREVLIG - Electrical Connection

ENGLISH 11
Electrical connection
WARNING. Disconnect the appliance
from the power supply.
- Installation must be carried out
by qualied personnel who know
the current safety and installation
regulations.
- The manufacturer declines all liability
for injury to persons or animals and
for damage to property resulting from
failure to observe the regulations
provided in this chapter.
- The power cable must be long enough
to allow the hob to be removed from the
worktop.
- Make sure the voltage specied on the
dataplate located on the bottom of the
appliance is the same as that of the
home.
}
}
}
}
}
}
}
}
1. Remove the terminal cover (A) by
unscrewing the screw and insert the
cover into the hinge (B) of the terminal.
2. Plug the power cord into the clamp and
connect the wires to the terminal block
as shown in the wiring diagram located
near the terminal.
3. Secure the power cable with the cable
clamp.
4. Close the cover (C) and screw on the
terminal with the screw removed.
For each connection to the network,
the hob automatically checks for a few
seconds.
}
}
}
}
}
}
}
}
= E (yellow-green)
N1 = N (blue)
N2 = N (blue)
L1 = R (black)
L2 = S (brown)
Connection to
main power
blue/grey
black/brown
yellow/green