Permanent Extra
Rinse
With this option you can permanently have an extra rinse when
you set a new pr
ogramme.
To activate/deactivate this option, hold the button
pressed
for 3 seconds until the indicator comes on/goes o on the
display
.
When it is activated, the appliance will default to this option after
you switch it o or change/reset the programme.
This option increases the programme duration.
Spin and addi‐
tional options
touch button
When you set a programme, the appliance automatically sets the
maximum spin speed allowed, ex
cept for programme Denim.
With this option you can decrease the default spin speed.
Touch repeatedly this button to:
• Decrease the spin speed. The display shows only the spin
speeds available for the set programme.
• Additional spin options No Spin
.
Set this option to deactivate all spin phases. The appliance
performs the only dr
aining phase of the selected washing
programme. Set this option for very delicate fabrics. The rin‐
ses phase uses more water for some washing programmes
• Activate the Rinse Hold
option.
The nal spin is not performed. The water of the last rinse is
not dr
ained out to prevent the fabrics from creasing. The
washing programme ends with water in the drum.
The indicator
is on display. The door stays locked and the
drum turns r
egularly to reduce creasing. You must drain the
water to unlock the door.
If you touch the button
, the appliance performs the spin‐
ning phase and dr
ains the water.
The appliance empties the water out automatically
after 18 hours appr
oximately.
Temperature
touch button
When you select a washing programme, the appliance automati‐
cally pr
oposes a default temperature. With this option you can
change the temperature.
The indicator of the set temperature comes on.
The indicator
= cold water.
Mode touch but‐
ton
Thanks to this button, a cycle can perform:
• Only washing: indicator is on (default mode).
• W
ashing and drying:
and indicators are on.
• Only drying
:
indicator is on.
ENGLISH 17
To Next Page
Loading...
