IKEA UPPSPEL - Desk Operation and Settings; Performing Basic Setting; Desk Initialisation Process; Controller Interface Overview

6
Basic Setting:
Push the arrow down button until the legs have reached
the lowest position and keep pressure on the button for 6
seconds more. Upon certain errors, this must be done twice in
succession. Now the desk is in initial position.
Initialisation instructions:
Step 1. Continuously press the
arrow down button for a few
seconds until the desk reaches its lowest position.
Step 2. Continuously press the
arrow down button a second
time until the display shows “RST”.
Step 3. Continuously press the
arrow down button a third
time until the desk moves slightly downwards.
When the desk stops moving and the display shows “72”, it is
ready to use.
Height Adjustment Controller
1 2 3 4
1. LED Display: Press any key once to wake up the LED display.
2. Up key
arrow up: Press and hold to raise the desk.
3. Down key
(Arrow down): Press and hold to lower the
desk.
4. Memory setting:
+ , , , :
• To save this current height: Press the button
, the
display will show "S-", then press preferred memory
button
, , , . This will bind the height to
this number.
• For Example, if you press
, the display will show “S-1”
etc…
• Memory button
, , , .
Note:
The desk's movement can be stopped at any time by pressing
any button.
Height settings will remain even if the desk’s power is cut.