7
Reset process:
Step 1: Press/hold the
down button for a few seconds until
the table reaches its lowest position.
Step 2: Press/hold the
down button a second time until the
display shows “RST”.
Step 3: Press/hold the
down button a third time until the
table slowly lowers. Once the table stops moving and the
display shows “72”, your desk is ready to use.
Lock/Unlock controller:
Lock the controller: Press and hold the
symbol for 10
seconds until the display shows “LOC”.
Unlock the controller: Press and hold the
symbol for 10
seconds until the display shows the actual height of the table.
Error Code Instructions
Error Code Reason Solution
E01 Overcurrent protection/short circuit See instructions for Reset/Initialisation.
E07 Motor line open circuit error See instructions for Reset/Initialisation.
H01 Over-heating Unplug from the wall socket and re-plug – or wait 18
minutes to let the motors cool before using them again.
RST Power failure See instructions for Reset/Initialisation.
888/000 Controller error Please contact IKEA Customer Service.
This device complies with Part 15 of the FCC Rules.
is device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation Science and Economic Development Canada's
licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interfer-
ence that may cause undesired operation of the device.
WARNING:
Any changes or modications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
quipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
The crossed-out wheeled bin symbol indicates that the item
should be disposed of separately from household waste. The
item should be handed in for recycling in accordance with local
environmental regulations for waste disposal. By separating a
marked item from household waste, you will help reduce the
volume of waste sent to incinerators or land-lls and minimise
any potential negative impact on human health and the
environment. For more information, please contact your IKEA
store.
To Next Page
Loading...
