Accessories
• Wire shelf x 2
For cookware, cake tins, roasts.
• Baking tray x 1
For cakes and biscuits.
• Grill- / Roasting pan x 1
To bake and roast or as pan to collect
fat.
• Core temperature sensor x 1
To measure how far the food is cooked.
• Panel shield x 1
It prevents control panel damage
because of heat, while grilling with the
oven door open.
Before first use
Warning! Refer to Safety
chapters.
Initial Cleaning
Remove all accessories and removable shelf
supports from the appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance before first use.
Put the accessories and the removable shelf
supports back to their initial position.
Setting the time
You must set the time before you operate
the oven.
Only the top oven works without
the set time.
The indicator for the Time of day function
flashes when you connect the appliance to
the electrical supply, when there was a
power cut or when the timer is not set.
Press the
or button to set the correct
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
Changing the time
You cannot change the time of
day if the Duration or End
function operates.
Press again and again until the indicator
for the Time of Day function flashes.
To set a new time, refer to "Setting the
time".
Preheating
Preheat the empty appliance to burn off the
remaining grease.
Preheat the two ovens. Heat up
one oven at a time.
Set the functions listed below, if
applicable.
1. Set the function and the temperature
to 250ºC.
Let the appliance operate for 1 hour.
2. Set the function and the temperature
to 250ºC.
Let the appliance operate for 15
minutes.
3. Set the function and the temperature
to 250ºC.
Let the appliance operate for 15
minutes.
Accessories can become hotter than usual.
The appliance can emit an odour and
ENGLISH
9
To Next Page
Loading...
