GB | Operating Instructions
8
3. Put the switch to the “I” position.
(1) Switch
4. Pull out the choke knob to the second-stage position.
The choke will close and the throttle lever will then be
set in the starting position.
(1) Throttle lever
(2) Throttle interlock
(3) Choke knob
(a) When the engine
is cool
(b) When the engine is
warm up
(c) After the engine
starts
NOTE
When restarting immediately after stopping the engine.
Choke knob in the rst-stage position (choke open and
throttle lever in the starting position)
NOTE
Once the choke knob has been pulled out, it will not
return to the operating position even if you press down
on it with your nger. When you wish to return the choke
knob to the operating position, pull out the throttle lever
instead.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously.
6. When ring occur, push in the choke knob and pull
the starter again to start the engine.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
WARNING
Before you start the engine, make sure the saw chain is
not contacting anything.
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed
and see if chain oil is scattered off as shown in the gure.
(1) Chain oil
The chain oil ow can be changed by inserting a screw-
driver in the hole on bottom of the clutch side.
To Next Page
