your Bluetooth device.
Turn on the Bluetooth function of your mobile phone and enable the search or
scan function to find your speaker.
Select "MXSP-BT04" from the device list when it appears on your device
screen. If required, enter the pass code “0000” to pair (link) your speaker with
your mobile device.
2. If your speaker has been paired with a Bluetooth device before: After turning on
your speaker, it will search for the last paired device. The LED will flash rapidly in
blue. If your speaker finds the paired Bluetooth device, a beep is heard and the
LED will begin flashing at a slower rate.
Note:
Fast flashing is when the LED lights up 3 times every second.
Slow flashing is when the LED lights up 1 time every 6 seconds.
3. After successfully pairing (linking), you can begin playing music from your
Bluetooth device wirelessly to the speaker.
4. Press the Volume Up (+) / Down (-) button on your Bluetooth device to adjust to
the desired volume level. Alternatively, on your speaker press the “+” button to
increase the volume (A beep alert sounds when the volume has reached the
maximum level). Press the “-” button to decrease the volume.
Notes:
1. Refer to the manual of your mobile phone, tablet, PC, computer or other
Bluetooth enabled device for Bluetooth operation, since it may vary from
model to model.
2. If your Bluetooth device does not support A2DP profile, unfortunately it will not
play music through this speaker
3. If you are pairing (linking) your computer to the IKUone using Bluetooth, you
may need to set the speaker as your computer’s default sound device.
4. If the IKUone is left idle for about 5 minutes without linking to any Bluetooth
enabled device, the Bluetooth pairing mode will automatically turn off to save
battery power.
Using the IKUone as a Hands-free Bluetooth Speakerphone.
1. Link your mobile phone to the MXSP-BT04 via Bluetooth as described above.
(You may need to turn the speaker OFF and ON again to reactivate the Bluetooth
mode, unless you are using NFC function when pairing)
2. When receiving an incoming call on your mobile, tap the ANSWER/
PLAY/STOP/PICK UP/HANG UP button on the speaker to switch the incoming
call to the IKUone. A short beep sound will be heard confirming the call was
answered. Complete your call using the built-in microphone and speakerphone on
the IKUone.
3. Adjust the volume control of unit to obtain the desired sound level.
4. To end the call, just tap the ANSWER/ PLAY/STOP/PICK UP/HANG UP button
again on the IKUone. A short beep sound will be heard and the call will end. If you
were playing music from your mobile to the IKUone before answering the call, the
music will automatically resume playing when you hang up.
5. To ignore an incoming call, simply tap the ANSWER/ PLAY/STOP/PICK UP/HANG
UP button on the speakerphone for about 2 seconds. A beep sound will be heard
and the call will be ignored.
Re-linking to your mobile phone
If your mobile phone is already paired (linked) with the speakerphone, but became
unlinked even with both Bluetooth devices turned on, then you can re-link them by:
1. Turning off the speaker and then turning it on again to re-link your mobile phone.
The LED INDICATOR will flash three times with two short beeps and then flash
rapidly for around 2 seconds if the speaker and your mobile phone have been
To Next Page
Loading...