iLive IKBC384S - Listening to Radio; Antenna Setup and Manual Tuning; Preset Radio Channels



LISTENING TO RADIO
TO SET UP ANTENNA
1. Extend FM antenna fully and rotate the unit to the best orientation for the best reception.
TO TUNE THE RADIO TO DESIRED CHANNEL MANUALLY
1. Press the
button to turn on the unit.
2. Press the SOURCE button to select RADIO mode. The radio frequency show on display.
3. Press and hold the SKIP / TUNE buttons for 2 seconds (release when the frequency in
the display starts to run automatically) the unit will scan upward or downward until a
channel with strong signal is found and stop at this channel.
4. Repeat the step 2 for tuning upward or download for searching other radio channel.
5. Press the VOLUME buttons to adjust the speaker volume, level.
6. To turn off the radio, press the
button once.
PRESET RADIO CHANNEL
1. Press the
button to turn on the unit and press SOURCE button to select radio mode.
2. Check whether the current frequency is the radio channel to be preset. If not, press and
hold SKIP / TUNE buttons for 2 seconds to scan for a radio channel.
3. Press the MEM button once that the "P01"" icons are displayed and "MEM" icon blinks.
4. Press M+ or M- buttons to select the present preset station from 1 to 20 and stop at the
desired preset station.
5. Press MEM button once to confirm and store the channel to the selected preset station.
6. Repeat step 2 to 5 to preset other radio channel.
NOTE:
All preset stations will be stored in the memory and its backup by Lithium battery
SELECT PRESET STATION
1. Press the
button to turn on the unit and press SOURCE button to select RADIO
mode.
2. Radio channel is resumed to the last setting.
3. Press the M+ or M- button once to go to the previously activated preset station.
4. Press the M+ or M- button repeatedly to walk through all preset stations (looping
P1-->P2=>P3...=>P20=>P1). Radio broadcast can be heard during the selection.
CHECK THE CLOCK TIME IN RADIO MODE
In radio mode, press DISPLAY button that the display show the clock time now. After 5
seconds the display will return to previous frequency mode automatically.