EasyManuals Logo

ILX Lightwave LDX-3200 Series User Manual

Default Icon
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
OPERATING IN REMOTE CONTROL
CHPT 3
PAGE 12
LDX-3200 Series ERROR MESSAGES
Error Code Explanation
E-001 Memory allocation failure.
E-103 <DEFINITE LENGTH ARBITRARY BLOCK PROGRAM DATA> length too long.
E-104 <NON-DECIMAL NUMERIC PROGRAM DATA> type not defined.
E-105 <DECIMAL PROGRAM DATA> exponent not valid.
E-106 <DECIMAL PROGRAM DATA> digit expected.
E-123
E-124
Command not found.
<program mnemonic> Lookup, failed because query/command type match failed.
E-126 Too few or too many program data elements.
E-201 <PROGRAM DATA> value out of range.
E-202 <PROGRAM DATA> will not convert to valid type.
E-203 Security violation, command is not available without clearance.
E-205 <PROGRAM DATA> is not a Boolean value or word.
E-207
E-209
<PROGRAM DATA> will not convert to an unsigned 16-bit value.
<PROGRAM DATA> will not convert to an unsigned 32-bit value.
E-210 <PROGRAM DATA> will not convert to a floating point value.
E-211 <PROGRAM DATA> will not convert to a character value.
E-213 <PROGRAM DATA> is incorrect block data length.
E-214
E-302
<PROGRAM DATA> length exceeds maximum.
Query error. Device was addressed to talk, but GPIB Controller failed to read all of the <RESPONSE
MESSAGE>.
E-501 LASER interlock disabled output.
E-503 LASER open circuit disabled output.
E-504
E-505
LASER current limit disabled output.
LASER voltage limit disabled output.
E-507 LASER Power limit disabled output.
E-510 LASER out of tolerance disabled output.
E-511 LASER control error disabled output.
E-512 Analog section status is all 1's or all 0's (power down).
E-513 Serial EEPROM checksum error.
E-515 Laser Output must be off to change ranges.
E-516 Incorrect Configuration for Calibration Sequence to start.
E-519 Setting a measurement is only valid during the calibration phase for that measurement. User has tried to
calibrate a measurement without first entering the required calibration mode.
Table 3.5 LDX-3200 Series Error Codes
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ILX Lightwave LDX-3200 Series and is the answer not in the manual?

ILX Lightwave LDX-3200 Series Specifications

General IconGeneral
BrandILX Lightwave
ModelLDX-3200 Series
CategoryPortable Generator
LanguageEnglish

Related product manuals