ILX Lightwave LDX-3200 Series User Manual

COMMAND REFERENCE CHPT 4
PAGE 1
CHAPTER 4
COMMAND REFERENCE
INTRODUCTION
This chapter is a guide to all of the device-dependent commands for the LDX-3200 Series Precision Current Source.
This chapter is divided into two parts. The first part contains an overview of the remote commands used by the
LDX-3200 Series Precision Current Source. The second part contains all of the LDX-3200 Series Precision Current
Source commands in alphabetical order. Figure 4.1 shows the format for the device command descriptions in this
chapter. The commands which emulate local (front panel) operation are denoted by the solid box next to the Local
label in the upper left corner of the command description.
LDX-3200 SERIES DEVICE-DEPENDENT COMMANDS
NAME PARAMETERS FUNCTION
DELAY 1 Used to create a delay in the execution of further commands.
ERR? NONE Returns errors generated since the last query.
LAS:CALMD 1 Used to set the CAL PD (monitor responsivity) constant.
LAS:CALMD? NONE Returns the CAL PD (monitor responsivity) constant.
LAS:CAL:CONST? 1 Factory use only.
LAS:CAL:LDI NONE Used to enter the laser current calibration mode.
LAS:CAL:LDI? NONE Returns the ready state for entering the laser current calibration value.
LAS:CAL:LDV NONE Used to enter the laser voltage calibration mode.
LAS:CAL:LDV? NONE Returns the ready state for entering the laser voltage calibration value.
LAS:CAL:MDI NONE Used to enter the monitor photodiode current calibration mode.
LAS:CAL:MDI? NONE Returns the ready state for entering the monitor PD current calibration
value.
LAS:COND? NONE Returns the value of the LASER condition register.
LAS:DEC 0, 1 or 2 Used to decrease the laser current set point value by one or more steps.
LAS:DIS 1 Turns the LASER display on or off.
LAS:DIS? NONE Returns the LASER display value.
LAS:DIS:LDI NONE Turn on/off LASER display to show laser output current.
LAS:DIS:LDI? NONE Returns status of laser output current display, on/off.
LAS:DIS:LDV NONE Turn on/off LASER display to show laser output voltage.
LAS:DIS:LDV? NONE Returns status of laser output voltage display, on/off.
LAS:DIS:MDI NONE Turn on/off LASER display to show PD monitor current.
LAS:DIS:MDI? NONE Returns status of photo diode monitor current display, on/off.
LAS:DIS:MDP NONE Turns on/off LASER display to show PD monitor power.
LAS:DIS:MDP? NONE Returns status of photodiode monitor power display, on/off.
LAS:DIS:PARAM NONE Enables LASER display to show parameter values.
LAS:DIS:SET NONE Shows the LASER display set point corresponding to mode
LAS:DIS:SET? NONE Returns status of LASER set point display, on/off.
Table 4.1 LDX-3200 Series Device-Dependent Commands
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDX-3200 Series Specifications

General

Brand	ILX Lightwave
Model	LDX-3200 Series
Category	Portable Generator
Language	English