iM3 P6 User Manual

- 16 -
 Electromagnetic Immunity
The device is intended for use in the electromagnetic environment specified below. The user
must assure that the device is used in such an environment.
Immunity
Test Item
IEC 60601 Test Level
Compliance Level
Electromagnetic
Environment - Guidance
Electrostatic
discharge
(ESD)
IEC 61000-
4-2.
± 8KV for contact;
± 2KV, ±4 KV, ±8
KV, ± 15KV for air
± 8KV for contact;
± 2KV, ± 4KV, ± 8KV,
±15 KV for air
Floors must be wood,
concrete, cement or tiled.
If floors are covered with
synthetic material (carpet,
etc.), the relative humidity
must be at least 30%.
Electrical
fast
transients
IEC 61000-
4-4.
±2KV for power
supply lines; ±1 KV
for interconnect lines
±2KV for power supply
lines; ±1 KV for
interconnect lines
Mains power quality
should be that of a typical
commercial or hospital
environment (hospital,
clinic).
Surges
IEC 61000-
4-5.
±0.5KV, ±1KV (line
to line); ±0.5KV,
±1KV, ±2KV (line to
earth)
±0.5KV, ±1KV (line to
line); ±0.5KV, ±1KV,
±2KV (line to earth)
Mains power quality
should be that of a typical
commercial or hospital
environment.
Voltage
dips, short
interruptions
and voltage
variations
IEC 61000-
4-11.
 0% residual voltage
for 0.5 cycle.
 0% residual voltage
for 1 cycle.
 70% residual voltage
for 25 cycles.
 0% residual voltage
for 250 cycles.
 0% residual voltage
for 0.5 cycle.
 0% residual voltage
for 1 cycle.
 70% residual voltage
for 25 cycles.
 0% residual voltage
for 250 cycles.
Mains power quality
should be that of a typical
commercial or hospital
environment.
If the use of the device
requires continued
operation during power
mains interruption, it is
recommended that the
product be powered from
a separate power supply
(UPS, etc.).

iM3 P6 Specifications

General

Brand	iM3
Model	P6
Category	Media Converter
Language	English