Section VIII: System Maintenance
8-A. Hand piece maintenance
1. After each use, the hand piece and tip should be rinsed with clean water for about 20
to 30 seconds.
2. Inspect the hand piece cable daily to ensure it is in good condition.
3. For sterilization of the hand piece, please refer to Section IV.
8-B. TIP maintenance
Worn out tips can adversely affect performance, resulting in insufficient power and
vibration. Check tips regularly for wear and tear and replace as necessary. Tips should
be disposed of and replaced every 4-6 months.
8-C. Main Unit Maintenance
The housing of the iM3 P6, as well as the hand piece cord, should be cleaned and
disinfected (using alcohol or soap and warm water) on a daily basis.
Section IX: Electromagnetic Compatibility
The use of accessories or replacement parts other than those specified or sold by iM3 may
have the consequence of increasing the electromagnetic emissions or decreasing the immunity
of the device.
The device must not be used near other equipment or placed on top of it. If this cannot be
avoided, correct operation of the device in operating conditions must be checked prior to use.
Electromagnetic Emissions
The device is intended for use in the electromagnetic environment specified below. The user
must assure that the device is used in such an environment.
Electromagnetic Environment - Guidance
Conducted Disturbance
CISPR 11
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
nearby electronic equipment.
Radiated Disturbance
CISPR 11
The device is suitable for use in all
establishments, including domestic
establishments and those directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic Current
Emissions IEC 61000-3-2
Voltage Fluctuations &
Flicker IEC 61000-3-3
To Next Page
Loading...
Need help?
General
