16
34
63
48
59
24
25
74
2
34. Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Press Upright
(2) with a 3/8” x 3 3/4” Bolt (59), a 3/8” Flat Washer
(48) and a 3/8” Nylon Jam Nut (63). Make sure that
the Cable Trap is oriented as shown.
35
74
54
50
23
23
25
35. Remove both of the pre-assembled 3 1/2” Pulleys
(24) from the Adjustable Pulley Plates (23).
Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the upper hole in the Adjustable Pulley
Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon
Locknut (50). Make sure that the Cable Trap and
the Adjustable Pulley Plates are oriented as
shown.
24
33
74
5
0
25
8
24
33. Wrap the Ab Cable (74) around a 3 1/2” Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Press Frame (8)
w
ith a 3/8” x 3 1/2” Bolt (56), a 3/8” Flat Washer (48),
and a 3/8” Nylon Locknut (50). Make sure that the
C
able Trap is oriented as shown.
Route the Ab Cable (74) back through the lower
opening in the Press Frame (8) as shown.
48
56
To Next Page
Loading...
