Image IMTL59105.1 - User Manual

Questions and Answers

B
Brianna KennedyAug 12, 2025
How to fix Image Treadmill when the power does not turn on?
- S
  Stephanie BassAug 12, 2025
  If your Image Treadmill doesn't turn on, ensure the power cord is plugged into a surge suppressor that meets the specifications described on page 11 and that the surge suppressor is plugged into a properly grounded outlet. Note that the treadmill is not compatible with GFCI-equipped outlets. Also, make sure the key is fully inserted into the console. Finally, check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes, the circuit breaker has tripped. To reset it, wait five minutes, and then press the switch back in.
U
umartinezAug 18, 2025
What to do if my Image Treadmill turns off during use?
- A
  amandaholmesAug 18, 2025
  If the Image Treadmill's power turns off during use, check the reset/off circuit breaker. Also, ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and plug it back in. Try removing and reinserting the key from the console.
M
matthew52Aug 25, 2025
What to do if Image Treadmill walking belt is off-center or slips?
- V
  Vanessa RamirezAug 25, 2025
  To fix an off-center or slipping walking belt on your Image Treadmill, first remove the key and unplug the power cord. If the belt has shifted left, turn the left rear roller bolt clockwise 1/2 turn; if it has shifted right, turn the left bolt counterclockwise 1/2 turn. If the belt slips, turn both rear roller bolts clockwise 1/4 turn. Ensure you could lift each edge of the walking belt 2 to 3 inches off the walking platform. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the belt is centered and properly tightened.
K
kylie66Aug 30, 2025
Why does my Image IMTL59105.1 walking belt slow down when I walk on it?
- J
  Jason ThompsonAug 30, 2025
  To address a walking belt that slows down when you walk on your Image Treadmill: * Ensure you're using a single-outlet surge suppressor that meets the specifications described on page 11. * If the walking belt is overtightened, remove the key and unplug the power cord. Use an allen wrench to turn both rear roller bolts counterclockwise 1/4 of a turn. When correctly tightened, you should be able to lift each edge of the belt 2 to 3 inches off the platform. Keep the belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until properly tightened.
C
carlsontrevorSep 5, 2025
How to reset incline on Image IMTL59105.1 Treadmill?
- A
  Allison MasonSep 5, 2025
  To recalibrate the incline system of your Image Treadmill, insert the key into the console and press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.