Imax B5 - Page 9

NiMH/NiCd battery charging program
These programs are for charging NiMH
(Nickel-Metal-Hydride) or NiCd
(Nicdel-Cadmium) battery commonly
used for R/C model applications.
To change the charging current, press
start enter key to make it blink then
change the value using DEC or INC key.
The value will be stored by pressing start
enter key once.
To start charging, press start enter button
for more than 3
NIMH CHARGE
CURRENT
NIMH 2.0A
7.42A
CHG 022:45 00890
2.0A
Battery
type
This program simply charges
the battery using the current
you set. The charge current
ranges from 0.1 to 5.0A.
Pb (lead-sulphuric acid) battery
charging program
This is programmed for charging Pb
(lead-acid) battery with nominal voltage
from 2 to 12V. Pb batteries are totally
different from NiCd or NiMH batteries.
They can only deliver relatively lower
current compare to their capacity, and
similar restrictions definitely apply to
charge. So the optimal charge current
will be 1/10 of the capacity. Pb batteries
must not be charged rapidly. Always
follow the instruction is supplied by the
manufacturer of battery.
Pb6s 4.0A
12.59V
CHG 022:43 00682
Pb6s CHARGE
4.OA
12.0A
Charging
time
Battery
voltage
Charged
capacity
Charging
current
Set up the charge current on the
left and the nominal voltage of
the battery on the right. The
charge current ranges from 0.1
to 5.0A. and the voltage should
match with the battery being
charged. Start the charge
process by pressing start enter
key for more than 3 seconds.
Charging
time
Charging
current
Battery
voltage
Charged
capacity
The screen displays the current
state of charging. To stop the
process, press batt type stop
key once.
The audible sound indicates
you the end of process
The screen displays the state of
charging process. To stop
charging forcibly, press batt
type stop key once. The audible
sound indicates you the end of
process.
-
+
INC DEC
-
+
INC DEC
Batt type
stop
Start Enter
B5
li-ion/Polymer Balance Charger
-
+
INC DEC
Batt type
stop
Start Enter