IMBERA units with HC refrigerants (R290 / R600a) are designed to operate under a
specific electric voltage. Check unit’s serial label to make sure that the electrical
classification is adequate for installation (see page 5).
IMPORTANT: ground connection is a protection system for equipment connected to
electrical network. It is used in electrical installations to avoid current pass-through
to user due to an isolation failure of active conductors.
This unit must be connected to physical
ground. In case a short circuit occurs,
ground connection reduces the risk of
electrical shock.
Unit is equipped with a power cord with
a ground cable with a physical ground
connection plug. Plug must be connected to
an adequately-installed outlet and ground
connected; if you don’t have this type of
plug, it is your responsibility and obligation
to have it installed.
Please contact a certified electrician or
a certified technician if you have questions
about ground connections.
Never use extension cords, as this will
void the warranty.
Under no circumstances cut off or remove the third ground connection pin from
power cord. Do not use an adapter; if this recommendation is not followed, it may
cause burns or death to user due to electrical shock.
For optimal operation, it is recommended to have this equipment connected to a
dedicated circuit outlet that is for unit use only.
Due to inductive load from electronic components inside, GFCI outlets might trip.
We recommend not to install the cooler in GFCI outlets. Tripping GFCI outlets is
not covered by Warranty.
Connect plug firmly to electrical outlet making sure it is inserted all the way in.
Never unplug your refrigerator by pulling on the power cord. Always grip plug
firmly and pull straight out from the outlet.
Power cord
Unit is equipped with a polarized power cord, with ground connection. Do not attempt
to eliminate ground connection or use two-terminal adapters.
AVOID RISKS: if the power cord or other electronic components are damaged, only
the manufacturer or authorized technician may repair them to avoid danger, so as to
minimize the risk of possible ignition due to incorrect parts or improper service.
NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain
conditions, we strongly recommend against the use of an adapter plug. The incoming
power source to the cabinet including any adapters used must have the adequate
power available and must be properly grounded.
Only adapters listed with UL should be used.
13
GFCI
To Next Page
Loading...