11 | P a g e
SMP-RANGE
DO’S AND DON’TS
Do Install on a level service.
Do Ensure power supply isolator or socket is accessible with the peeler installed.
Do Clean the machine after each period of use.
Don’t Sit or stand on top of the peeler.
Don’t Place hands inside unit while discharging or peeling.
Don’t Use the unit outside.
MATERIAL CONTENT
The SMP peeler contains the following materials:
Metals Stainless steel, mild steel (inc plated), aluminium, brass and copper.
Plastics and rubber Polycarbonate, nylon, neoprene rubber and EPDM
Other Aluminium oxide, electrical components.
MAINTENANCE
Other than regular cleaning, the SMP-Range of peelers require no maintenance by the end user. It is
recommended that the unit is serviced by an IMC approved engineer at least once a year.
WARNING. Only suitably qualified personnel should service this equipment after becoming
familiar with all safety notices, installation, operation and maintenance procedures related to
the machine.
To Next Page
Loading...