7 | P a g e
SMP-RANGE
INSTALLATION
The SMP Peeler is supplied with a stand and is designed to be either free standing or screwed to the
floor (screwing to the floor is recommended). The control box is integral to the machine.
Place the machine in its desired location; level the machine by using a spirit level & adjusting the
levelling feet to suit. If required, mark through the holes in the feet the location of the fixing holes.
Remove the machine and prepare the floor for rawlplugs or other suitable floor fixings. Replace the
unit into working position and screw through the holes in the feet into the rawlplugs or other suitable
fixings. Tighten up the screws.
WATER SUPPLY
Connect the water supply pipe (IMC Inlet Hose Kit Part No. S58/062, or 12mm (1/2”) bore hose) to the
water inlet pipe located on the top of the lid and secure using hose clips. Fit the other end of the supply
pipe to a cold water supply that incorporates a tap or shut off valve that can be used to regulate the
water flow to approximately 3 – 4 litres per minute, experience will dictate how much water is required.
Too much and it will splash out of the opening in the lid, too little and waste will collect underneath the
peeler plate. During operation however, there may be minor splashing on the surface of the lid; if this
becomes severe, reduce water flow as required. The maximum water pressure for the supply is 10 bar.
Ensure that an old hose is not used.
PLEASE NOTE: These machines are fitted with a WRAS Approved Type A air-break to prevent back
syphonage into the mains supply. Some local authorities may nevertheless require connection is made
to a storage cistern rather than direct to the mains supply.
This applies to UK installations only. Overseas customers should install the machine in accordance with
local regulations.
If in doubt, check with your local authority
WASTE OUTLET
The peeler has two fixed internal waste outlet locations which both drain into the filter basket located
in the stand, if it is required to remove the waste outlet/s for any reason, it is ESSENTIAL to remove &
discard the gaskets & replace with new ones, (Part No. A11/026).
The waste is discharged from the peeler, through the filter basket and into the drain tray of the stand,
which has a 38mm waste pipe connection. This pipe may either discharge into a gully beneath the
machine or it may be connected via a shallow seal waste trap and fixed pipework into the waste water
system of the building.
To Next Page
Loading...
Need help?
General
