PROTOCOL COMMUNICATION
PT10789220
pag. 2/22
1. General description
The measuring instrument NEMO 96HD works in a Profibus network according to EN50170 with baud rates up to 3
Mbaud.
The functions through the Profibus interface are limited to the reading of the measured values.
The setting of parameters must be done in the local setup.
NEMO 96HD - measuring data can be processed in the PLC software and can be displayed e.g. with corresponding
visualisation systems or operator panels.
2. Installation of NEMO 96HD Profibus
In the PLC project, NEMO 96HD Profibus is to be installed with the corresponding GSD file.
The address space as a Profibus DP slave is between 01 to 126 decimal.
The parameter that must be set locally is :
The address : 01 .. 126
The selected address will be accepted after the device power up.
A module reserves, in the decentralised peripheral field, the following :
- 32 bytes input periphery
- 32 bytes output periphery
To Next Page
Loading...
