- And to extract the concrete residues with a brush from the hole just made and con a pump to completely
free the hole or from the dust residue;
- Hypoxic the machine to match the holes made to the holes in the base of the washing machine.
- Insert the steels anchors through the holes of the base of the washing machine, inside the holes made in the
concrete
- Close with torque wrench the anchor, according to the data given in the table above
ATTENTION!
For all installed rigid machines, test by having the washing machine perform a centrifuge at full load (maximum
speed and nominal load), verifying that:
- there are no vibrations.
- there is no noise.
- there are no points of contact or sliding between the basket and the tank of the machine.
IMPORTANT: If one of the problems listed above occurs, it means that the machine has not been properly fixed
to the ground. Re-verify:
- the correct bubble execution of the concrete base.
- the correct anchoring of the concrete base to the rest of the floor.
- the correct closure of the steel anchors.
9. ELECTRICAL CONNECTION
The electrical connection must be carried out by professionally qualified personnel and must meet the
requirements of current local and national rules and / or regulations.
ATTENTION!
Check that the supply voltage corresponds to that indicated in the license plate data.
To Next Page
Loading...