Need help?Do you have a question about the IMET BS 300/60 SHI and is the answer not in the manual?
Information on EMC compliance and installation recommendations for industrial environments.
Details on directives and harmonized norms followed for machine safety and EMC.
Additional health and safety instructions, including vibration limits.
Safety protections applied on the saw, according to current legislation.
Details on the machine's electrical equipment and safety standards.
Protections implemented to prevent accidental contact with moving parts.
Recommendations for adequate lighting in the working area for operator safety.
Procedure for setting up the machine for cutting materials.
Device for automatic detection of start and end cut points.
Operating the machine in manual mode without compressed air.
Methods to stop the machine cycle at any time, including emergency stops.
Using the electronic inverter for variable blade speed control.
Step-by-step guide for replacing the saw blade safely and correctly.
Routine maintenance tasks to be performed daily, weekly, and monthly.
List of machine-related defects and checks to perform for identification.
List of machine parts to check when troubleshooting specific issues.
Common band-related defects, their causes, and suggested solutions.
Information required when requesting spare parts from technical service.
To Next Page
General
