IMET HYDRA - STOP Test Procedure Part 2

TROUBLE SHOOTING TX
TX
“STOP” test
p
rocedure Part2
p
Push the STOP button (and let it pressed) while the led is flashing, then press START.
At this point one of the following three cases can occur:
A) if the STOP circuit is perfectly working, after releasing the STOP button and pressing
the START button, the transmitter will turn on and work normally
B) if after the first test the LED keeps flashing rapidly, it is necessary to repeat the test
procedure (up to 4 times) untill you turn into case A) o C)
C) If the LED starts to flash indicating the error code
“
STOP circuit failure
”
contact your
C)
If
the
LED
starts
to
flash
indicating
the
error
code
STOP
circuit
failure
,
contact
your
dealer for repairing/replacing the STOP Button
13