Need help?Do you have a question about the IMET HYDRA and is the answer not in the manual?
Important safety warning regarding repairs and genuine spare parts.
Steps to perform before troubleshooting to identify common issues.
Defines key terms like Passive Emergency Stop, TX/RX, EEPROM, and Frequency Change.
Identifies common anomalies occurring at first or subsequent transmitter activations.
Explains the meaning of TX LED status for OFF, Flashing regularly, and ON while START is pressed.
Details TX LED indications for three short + long flashes, Morse code, flashing fastly, single short flash, and low intensity.
Describes TX LED status for ON, flashing with groups of 5 flashes, and proportional commands/PIN code.
Explains how to interpret Morse code flashing patterns for transmitter error codes.
Provides a list of transmitter error codes with their binary and hexadecimal representations.
Explains the initial step of the STOP test procedure for transmitter anomalies.
Details the outcomes and actions after performing the STOP test procedure.
Provides detailed information on troubleshooting EEPROM related issues in the transmitter.
Lists and explains the indications of LEDs on the receiver unit.
Outlines common receiver anomalies and their corresponding possible solutions.
Explains how to read and interpret error codes displayed by the receiver's LED.
Lists receiver error codes with their binary and hexadecimal representations.
Provides specific details and solutions for RX error code 11.
Details troubleshooting steps for power pack issues in HYDRA systems.
Lists required information for contacting the manufacturer for unlisted problems.
General| Brand | IMET |
|---|---|
| Model | HYDRA |
| Category | Remote Control |
| Language | English |
To Next Page
