IMET M880 - Table of Errors for the Transmitter Unit

M880 ERROR CODES V.00 – ENGLISH
M880 CODICI DI ERRORE EN V.00 DP184 7
1.3 TABLE OF ERRORS FOR THE TRANSMITTER UNIT
RX HEX
Code
TX ZIP
Code
Description and Information
0x0400 112
Radio communication error. Restart the system or if the problem
persists contact the service center.
0x0401 113 System requires a reboot.
0x0402 114
Transmitter unit logic board error, try to programming the software
again or contact the service center.
0x0403 115
Error on the Transmitter Logic board.
Contact the service center.
0x0404 116
0x0405 121
Error in the power supply of the transmitter unit, check the power
supply voltages or contact the service center.
0x0406 122
0x0407 123
Error on the Transmitter Logic board.
Contact the service center.
0x0408 124
0x0409 125 Repeat the pairing between the transmitter unit and the receiver unit
.
0x040A 126
Error on the Transmitter Logic board.
Contact the service center.
0x040B 131 Check the wiring of the control wire.
0x040C 132
Software inconsistency between transmitter and receiver unit. Re-
program or contact the service center.
0x040E 134
Error on the Stop push button
0x040F 135
0x0410 136
Transmitter Logic board error.
Contact the service center
0x0411 141
Error in the power supply of the transmitter.
Check the battery status or contact the service center.
0x0412 142
0x0413 143 Error on the Stop push button
0x0414 144
Error on the Transmitter Logic board.
Contact the service center.
0x0415 145
Repeat the pairing between the transmitter unit and the receiver unit
or contact the service center.
0x0416 146
Error in the power supply of the transmitter.
Check the battery status or contact the service center.
0x0417 151
0x0418 152
Transmitter Logic board error.
Contact the service center.
0x0419 153 Error in the start button. Contact the service center.
0x041A 154
Transmitter Logic board error.
Contact the service center.
0x041B 155
Repeat the pairing between the transmitter unit and the receiver unit
or contact the service center.
0x041C 156
0x041D 161
Wait for the software recovery procedure (AMD).
Approximately 5 minutes.
0x041E 162
0x041F 163
Repeat the pairing between the transmitter unit and the receiver unit
or contact the service center.
0x0420 164
0x0423 211
Transmitter Logic board error.
Contact the service center.
0x0424 212 Remove the EEPROM from the transmitter and restart.
0x0425 213
Transmitter Logic board error.
Contact the service center.
0x0426 214
0x0427 215 Wait for the software recovery procedure (AMD).