2.2 Receiver Set-up
Using the bracket included, mount this onto a staff or grade rod.
Turn the receiver on and raise or lower the receiver on staff until it makes
a continuous beeping sound. This is the point level with the instrument.
The receiver has two settings; a course and a fine setting. The band
width and the audio volume can be adjusted using the receiver’s
buttons.
LCD display Reception window
On/Off Button
Volume Button
Fine/course Button Staff Bracket
Standard Leveling Set-up
When set up the instrument will create a laser beam across the entire
work site to a radius of 200m and the receiver will give a signal at all
points within the instruments rang
To Next Page
Loading...
