What to do if the imex Measuring Instruments low battery light is flashing and it won't turn on?
If the low battery light is flashing and your imex Measuring Instrument won’t power on, first recharge the batteries. If that doesn’t work, inspect the battery terminals to ensure they are clean and the polarity is correct. If the issue persists, the batteries may be overcharged and need replacement.
How to fix an out of level alert on imex Measuring Instruments?
If your imex Measuring Instrument displays an out-of-level alert and won’t self-level, ensure the instrument is within 5º of level before switching it on. Also, verify that the manual level switch is not activated and confirm that the unit hasn’t been bumped or moved.
What to do if the receiver is not working with imex Measuring Instruments?
If the receiver for your imex Measuring Instrument isn’t working correctly, start by checking and replacing the receiver batteries if necessary. Ensure the receiver is within a 250m radius of the unit. Also, make sure the laser windows are clean, free of dust, and not obstructed.
Why are the out of level and battery lights on and the imex Measuring Instruments not working?
If your imex Measuring Instrument shows both an out-of-level alert and the battery light, and it's not working properly, the environment might be too harsh, or there might be direct sunlight exposure. Move the unit to a shaded area where the temperature is below 50ºC.
Details the components of the Imex 66R rotating laser, including the laser module, beam windows, and control panel.
Explains the functions of the control panel buttons: On/Off, H.I. Alert, and battery indication lights.
Describes the semi-conductor diode, laser beam visibility, and rotation for scanning surfaces.
Instructions for placing the unit on a tripod, switching it on, and understanding leveling lights.
Explains how to activate and interpret the H.I. alert mode for accurate results and automatic stopping.
Guide to mounting the receiver on a staff, finding the level point via beeping, and adjusting settings.
Details how the instrument creates a laser beam across the work site for detection by the receiver.
Locates the battery case and provides instructions for changing batteries, checking polarity.
How to charge NiMH batteries, including the battery indication light and avoiding overcharging.
Specifies the standard full charge time for NiMH batteries and mentions car charger accessory.
Instructions for removing the NiMH pack and inserting alkaline batteries into the separate pack.
Procedure for checking horizontal accuracy by marking lines on a wall and measuring differences.
Details the 5-year warranty for the Imex rotating laser range and where to register.
Advises on recommended calibration frequency by a registered service centre for optimal performance.
Guidance on preventing damage, storage conditions, transport, and cleaning to maintain the instrument.
General| Brand | imex |
|---|---|
| Model | 66R |
| Category | Measuring Instruments |
| Language | English |
To Next Page
