–11–
Step 2: Using the provided screw (#1), attach the drainage pipe clip (#2) near the drainage port.
1
2
Step 3: Place the drainage pipe (#1) onto the drainage port (#2) and fasten with the drain-
age pipe hoop (#3). Place the rubber stopper (#4) at the top of the pipe, clip the hose to
the unit (#5), and drain the unit in a suitable location as needed.
1
2
3
4
5
TESTING UNIT OPERATION
Turn the unit on by plugging in the power cord and pressing the ON/OFF button. Press the
mode button to cycle through the various operation modes.
Note: if the ambient temperature is below 61°F, the cooling mode will not function.
To Next Page
Loading...
