18
CARE & MAINTENANCE:
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean the
unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by manu-
facturer or its agency.
AIR FILTER CLEANING:
Clean the air lter at least once every two weeks to prevent infe-
rior fan operation because of dust.
REMOVAL: This unit has three lters. First remove the Upper l-
ter. Then remove Lower lter A and then Lower lter B as shown
in Figure R.
CLEANING: Wash the air lter by immersing it gently in warm
water (about 104°F/ 40°C) with a neutral detergent. Rinse the
lter and dry it in a shady place.
MOUNTING: Reinstall The upper lter, Lower lter B and then
Lower lter A.
UNIT ENCLOSURE:
Use a lint-free cloth soaked with neutral detergent to clean the
unit enclosure. Finish by wiping with a dry clean cloth.
BEFORE STORING OR NOT USING A UNIT
FOR LONG PERIODS OF TIME:
Remove the rubber plug at the back of the unit and attach a
hose to drain outlet. Place the open end of the hose directly
over the drain area in your oor or receptacle. (See gure F on
page 10.)
Remove the plug from the bottom drain outlet, all the water in
the bottom tray will drain out. (See Figure E on page 10.)
Keep the appliance running on FAN mode for half a day in a
warm room to dry the appliance inside and prevent mold from
forming.
Stop the appliance and unplug it, wrapped the cord and bundle
it with the tape (Figure S). Clean the air lter and reinstall it (see
above). Remove batteries from the remote controller.
Lower filter A
Fig. R
Upper filter
Lower filter B
Power cord
buckle
Power plug
dummy socket
Fig. S
To Next Page
Loading...
