ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Plug the two Stabilizer End Caps (#23) onto the bottom of the two Rear Upright
Beams (#1).
B.) Connect the two Rear Upright Beams by a Cross Brace (#2) in the Mid-span. Secure
them with two M10 x 3 1/8” Carriage Bolts (#26), one Curved Bracket (#3), two ∅ ¾”
Washers (#32), and two M10 Aircraft Nuts (#35) on each end of the Cross Brace.
C.) Insert the Backrest Adjustment Bar (#4) through a selected hole to obtain desired
incline of Backrest.
DIAGRAM 1
5
To Next Page