Impinj R705 Portal Gateway Reader Installation and Operations Guide
Version 0.1 2
1 Requirements, Certifications, and Warnings
1.1 Products Covered by this Guide
This guide pertains to Impinj R705 Portal Gateways with the following part numbers:
Gateway Communication Code Part Number
R705 FCC and Global IPJ-R705-FGX
R705 ETSI 865-868MHz IPJ-R705-EU1
R705 ETSI 916-919MHz IPJ-R705-EU2
R705 Japan IPJ-R705-JP
* Note: Will vary based-off of country-specific limits
1.2 Federal Communications Commission (FCC) Compliance
This equipment was tested and complies with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in accordance with the instructions, the equipment may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation and cause harmful interference to radio or television reception.
To determine if this equipment causes harmful interference to radio or television reception, turn the
equipment off and on. You are encouraged to try to correct the interference by one or more of the
following:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or a qualified radio/TV technician for assistance.
1.2.1 Per FCC 15.19(a)(3) and (a)(4)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
To Next Page
Loading...
