impinj R705 - Minimum Separation Distance; Canada; CE Marking and European Economic Area (EEA); Environmental Requirement

Impinj R705 Portal Gateway Reader Installation and Operations Guide
Version 0.1 3
Caution: Changes to this product or
modifications not expressly approved by the
party responsible for compliance could void your
authority to operate per FCC Part 15.
Attention: Les modifications apportées à ce
produit ou modifications pas expressément
approuvés par la partie responsable de la
conformité peuvent annuler votre droit à utiliser
par FCC Part 15.
1.2.2 Minimum Separation Distance
This device has been evaluated for compliance with FCC and IC RF exposure limits in a mobile
configuration. At least 34 cm of separation distance between the device and the user’s body must be
maintained at all times. This device must not be used with any other antenna or transmitter that has not
been approved to operate in conjunction with this device.
1.3 Canada
Industry Canada (IC) Compliance Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
The term “IC” before the radio certification
number only signifies that Industry of Canada
technical specifications were met.
Industrie Canada (IC) Conformité Son
fonctionnement est soumis aux deux conditions
suivantes:
1. Cet appareil ne doit as rovoquer
d’interférences.
2. Cet appareil doit accepter toute
interférence, y compris celles pouvant causer un
mauvais fonctionnement de l’appareil.
L’expression “IC” avant le numéro de certification
radio signifie seulement que l’industrie des
spécifications techniques Canada ont été
respectées.
1.4 CE Marking and European Economic Area (EEA)
RFID devices designed for use throughout the EEA must have a maximum radiated transmit power of
2W ERP in the frequency range of 865.6-867.6 MHz and 4W ERP for 916.1-918.9MHz. For other EEA
restrictions on RFID device use, refer to the Impinj Declaration of Conformity (DoC) located at
support.impinj.com.
1.5 Environmental Requirement
• Operating temperature: -20º C to +50º C (-4º F to +122º F)
• Humidity: 5% - 95% (non-condensing)