Impinj R705 Portal Gateway Reader Installation and Operations Guide
Version 0.1 4
• Sealing: IP50
1.6 Simplified EU Declaration of Conformity
Hereby, Impinj, Inc., declares that the radio equipment type IPJ-R705-EU1, IPJ-R705-EU2 is in compliance
with Directive 2014/53/EU, EMC Directive 2014/30/EU, and RoHS 2015/863/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://support.impinj.com/hc/en-us/articles/360005324979-EU-Declaration-of-Conformity
The EU countries indicated below have not approved RFID use in the 916.1 to 918.9 MHz
frequency band:
AT BE BG CZ DE EL ES FI HR IS IT LT
MT NL PL RO SE SK TR
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo
o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su operación no deseada.
1.7 Hardware Requirements
• TCP/IP network equipment is required to connect the gateway to a PC (Windows, Mac, or
Linux), or other network terminal. The network connection must provide power (PoE or
PoE+).
• Connecting to the gateway console port requires a USB cable with a micro-USB connector.
1.8 Supported Operating Environments
This section describes the environments in which you can access the RShell console that is used for
configuring, monitoring, and maintaining the gateway. The tools that you use when you access the
RShell console depend on the Operating System that is running on your computer.
Interface Protocol Microsoft Windows Linux
Ethernet SSH Port 22 SSH or Putty SSH
USB Host SSH Port 22 SSH or Putty SSH
Putty: https://www.putty.org/
1.9 Supported Communication Protocol
To Next Page
Loading...
