Impinj R705 Portal Gateway Reader Installation and Operations Guide
Version 0.1 5
For client control of the gateway, the gateway supports the EPCglobal Low Level Reader Protocol (LLRP)
v1.0.1. LLRP is an EPCglobal standard interface that allows communication with the gateway, which in
turn reads EPCglobal Gen 2 RFID tags.
1.10 Power Requirements
The RF transmit power is limited by the type of power supplied (PoE, or PoE+).
Power Source TX (Max)
802.3at PoE+ 30.0 dBm
802.3af PoE 30.0 dBm
Operating above +30 dBm requires professional installation to comply with radio regulatory laws in
many countries.
1.11 Before You Begin
Warning: Please read this document in its entirety before operating the Impinj R705 Gateway, as
serious personal injury or equipment damage may result from improper use.
Avertissement: S’il vous plaît lire ce document dans son intégralité avant d’utiliser le Impinj R705
Gateway, comme des blessures graves ou des dommages matériels peuvent résulter d’une mauvaise
utilization.
2 Introduction
The Impinj R705 portal gateway is sold to product companies, which embed the device within their
product providing overall enclosure and device control. The device does not include an enclosure and is
not intended for sell to the general public.
2.1 Product Tour
The gateway radiates RF energy from the antenna element side, as shown below.
To Next Page
Loading...
