impro technologies HMW701-0-0-NN-XX - S-Bus and Power Wiring for Remote Installation

20 pages

To Next Page

To Previous Page

S-Bus and Power Wiring for Remote Installation

Figure 8 shows how to power the Impro WRM and its relay-driven loads in an

“unclustered”, remote installation position.

Figure 8: Typical S-Bus and Power Wiring for Remote Installation

NOTE: The wiring of the RTE, DOS and Reader Terminals remains the same as shown

on pages 12 to 14.

HMW300-0-0-GB-00 October 2013 Page 16