Inateck BCST-50 - Standard 2 of 5 Settings

14
7.12 Standard 2 of 5
7.12.1 Scan the two-dimensional codes below to read/not to read Standard 2 of 5
7.12.2 Only decode Standard 2 of 5 of a certain length range
Users can set to only decode Standard 2 of 5 of a certain length range.
For example, to decode Standard 2 of 5 of the range of 4 - 20 digits:
Scan the barcode below, then scan “0”, "4", "2", "0" in Appendix 1.
If the barcode of a certain length range cannot be read, please read the barcode
" Standard 2 of 5 of any length". Please contact us if the problem still occurs.
7.12.3 Verify Standard 2 of 5 Check Digit
7.12.4 Output Standard 2 of 5 Check Digit
Enable
Standard 2 of 5 of a certain length range
Enable
Enable
（*）Disable
Standard 2 of 5 of any length
（*）Disable
（*）Disable