Need help?Do you have a question about the Inateck FE2013 and is the answer not in the manual?
General| Model | FE2013 |
|---|---|
| Interface | USB 3.0 |
| Supported Drive Size | 2.5 inch |
| Compatible Drive Type | SATA HDD/SSD |
| Max Support Capacity | 6TB |
| Transfer Speed | Up to 5Gbps |
| Type | External Hard Drive Enclosure |
| Material | Plastic |
| Operating System Compatibility | Windows, Linux, Mac |
Procedure to open the HDD enclosure by separating its parts in opposite directions.
Steps for inserting the hard disk into the enclosure, ensuring the SATA interface is aligned.
Instructions for closing the HDD enclosure after the hard drive has been installed.
Guidance on connecting the enclosure to a computer using the provided USB cable.
Instructions for switching on the enclosure and verifying drive recognition in the file manager.
Ensure data access is stopped before removing the enclosure to prevent data loss.
Verify hard drive power requirements match the USB port output for normal operation.
The drive enters sleep mode after 30 minutes of inactivity, indicated by a breathing LED.
Troubleshooting steps if the drive appears as 'New Disk' or is not recognized.
Use the sponge pad to prevent hard drive sliding inside the enclosure if it's too thin.
To Next Page
